Detcon FP-524D INSTRUCTION MANUAL Instrukcja Użytkownika Pobierz pdf (Strona 36)

Model FP-524D

FP-524D Instruction Manual Rev. 1.4 Page 32 of 39

Faulty 4-20mA Output

If sensor has a normal reading with no faults displayed, and the 4-20 mA signal output is 0mA….

Check that wiring is properly connected at terminal blocks and through to controller inputs.

The 4-20mA output loop must be closed (resistance of < 1000 ohms) to avoid the Loop Fault.

Perform a “Signal Output Check” sequence via Section 3.5.6 and verify 4-20mA output with current meter.

Swap with a known-good transmitter module to determine if the transmitter module’s 4-20mA output circuit is

faulty.

If the 4-20mA current loop is still out of tolerance, contact Detcon at [email protected], or contact Detcon

customer service.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43

Brak uwag

Detcon FP-524D INSTRUCTION MANUAL Instrukcja Użytkownika Strona 36